Factory Direct Re-Verber-Ray Replacement Parts

USE CODE 'SUMMER5' FOR 5% OFF

Shopping cart

Pick List

Re-Verber-Ray High Intensity Heater Parts

Re-Verber-Ray® high-intensity infrared space heaters are an ideal heating solution for areas with high air filtration or high ceilings, or where you need to spot heat. Our exclusive design has a proven history and includes a perforated ceramic emitter for maximum conversion to infrared radiation, plus a variety of BTU and control options

 

Charts

RE-VERBER-RAY DR 45-60 NFS-2 120V HIGH INTENSITY HEATER (Ver. 03/97)

Control Components

Part DescriptionPart Number
Combination Gas ValveVR4205M-1308
Circuit BoardMARK 10DX-117
Wiring HarnessDRWH-120
Ignition Wire, High VoltageHVW-18
Ignition Wire, Low VoltageLVW-18
Main Burner Electrode32-508

 

 

Core Components

Part DescriptionQty.1Part Number
Orifice2Consult Factory
Rayhead (assembled with ceramics)2DR-RH
*Rod for Rayhead, 17-3/8″18DR-LROD
Short Rod for Rayhead1DR-SROD**
Heater Reflector Assembly1DR-2REF
Pilot Access Door w/Screw1DR-DOOR
Pilot Shield1F10-PS
Pilot Line (Straight)1PL-2
Union Fitting, 3 Piece1DR-MU
DR Cross Over Bracket (45-60 MBH Nat; 45-100 MBH LP only)DR-CO
DR Flash Shield (45-60 MBH)1DR-FLSH 2
1/4″ – 20 x 1/2″ MS Bolt6DR-BOLT
1/4″ – 20 Hex Nut6DR-NUT

1Indicates the quantity of this part originally installed on the heater.  When replacing, you may choose to replace only the non-functioning part(s). If quantities are not indicated consult factory.

*30, 45 & 55 MBH PFS, PMV & PT models use DR-RHP.

**NFS, PFS models require 1 DR-SROD in addition to 17 DR-LROD‘s.