Factory Direct Re-Verber-Ray Replacement Parts

USE CODE 'SUMMER5' FOR 5% OFF

Shopping cart

Pick List

Re-Verber-Ray High Intensity Heater Parts

Re-Verber-Ray® high-intensity infrared space heaters are an ideal heating solution for areas with high air filtration or high ceilings, or where you need to spot heat. Our exclusive design has a proven history and includes a perforated ceramic emitter for maximum conversion to infrared radiation, plus a variety of BTU and control options

 

Charts

RE-VERBER-RAY DR 75-100 NFS-2 120V HIGH INTENSITY HEATER (Ver. 03/97)

Control Components

Part Description Part Number
Combination Gas Valve VR4205M-1308
Circuit Board MARK 10DX-117
Wiring Harness DRWH-120
Ignition Wire, High Voltage HVW-18
Ignition Wire, Low VoltageLVW-18
Main Burner Electrode 32-508

 

 

Core Components

Part Description Qty. 1 Part Number
Orifice3Consult Factory
Rayhead (assembled with ceramics)3 DR-RH
*Rod for Rayhead, 17-3/8″9 DR-LROD
Short Rod for Rayhead1 DR-SROD **
Heater Reflector Assembly 1 DR-3REF
Pilot Access Door w/Screw1 DR-DOOR
Pilot Shield1 F10-PS
Pilot Line (Straight)1 PL-2
Union Fitting, 3 Piece1 DR-MU
DR Cross Over Bracket (45-60 MBH Nat; 45-100 MBH LP only) DR-CO
DR Flash Shield (30 MBH)1 DR-FLSH 3
1/4″ – 20 x 1/2″ MS Bolt4 DR-BOLT
1/4″ – 20 Hex Nut4 DR-NUT

1 Indicates the quantity of this part originally installed on the heater.  When replacing, you may choose to replace only the non-functioning part(s). If quantities are not indicated consult factory.

*30, 45 & 55 MBH PFS, PMV & PT models use  DR-RHP .

**NFS, PFS models require 1  DR-SROD  in addition to 8  DR-LROD ‘s.