Factory Direct Re-Verber-Ray Replacement Parts

USE CODE 'SUMMER5' FOR 5% OFF

Shopping cart

Pick List

Re-Verber-Ray High Intensity Heater Parts

Re-Verber-Ray® high-intensity infrared space heaters are an ideal heating solution for areas with high air filtration or high ceilings, or where you need to spot heat. Our exclusive design has a proven history and includes a perforated ceramic emitter for maximum conversion to infrared radiation, plus a variety of BTU and control options

 

Charts

RE-VERBER-RAY DR 30 PFS-2 25V HIGH INTENSITY HEATER

Control Components

Part DescriptionPart Number
Combination Gas ValveVR8205A-2081
Circuit BoardMARK 10X-24
Wiring HarnessN/A
Main Burner Electrode32-508
Ignition Wire, High VoltageHVW-18
Ignition Wire, Low VoltageLVW-18
  

 

 

Core Components

Part DescriptionQty.1Part Number
Orifice1Consult Factory
Rayhead (assembled with ceramics)1DR-RHP
*Rod for Rayhead, 17-3/8″9DR-LROD
Short Rod for Rayhead1DR-SROD**
Heater Reflector Assembly1DR-1REF
Pilot Access Door w/Screw1DR-DOOR
Pilot Shield1F10-PS
Pilot Line (Straight)1PL-1
Union Fitting, 3 Piece1DR-MU
DR Cross Over Bracket (45-60 MBH Nat; 45-100 MBH LP only)DR-CO
DR Flash Shield (30 MBH)1DR-FLSH 1
1/4″ – 20 x 1/2″ MS Bolt4DR-BOLT
1/4″ – 20 Hex Nut4DR-NUT
   

1Indicates the quantity of this part originally installed on the heater.  When replacing, you may choose to replace only the non-functioning part(s). If quantities are not indicated consult factory.

*30, 45 & 55 MBH PFS, PMV & PT models use DR-RHP.

**NFS, PFS models require 1 DR-SROD in addition to 8 DR-LROD‘s.