Factory Direct Re-Verber-Ray Replacement Parts

5% Off Savings! Use Coupon Code "WINT5"

Shopping cart

Pick List

Re-Verber-Ray High Intensity Heater Parts

Re-Verber-Ray® high-intensity infrared space heaters are an ideal heating solution for areas with high air filtration or high ceilings, or where you need to spot heat. Our exclusive design has a proven history and includes a perforated ceramic emitter for maximum conversion to infrared radiation, plus a variety of BTU and control options

 

Charts

RE-VERBER-RAY DR 45-60 PFS-2 25V HIGH INTENSITY HEATER

Control Components

Part Description Part Number
Combination Gas Valve VR8205A-2081
Circuit Board MARK 10X-24
Wiring Harness N/A
Main Burner Electrode 32-508
Ignition Wire, High Voltage HVW-18
Ignition Wire, Low Voltage LVW-18
   

 

 

Core Components

Part Description Qty.1 Part Number
Orifice 2 Consult Factory
Rayhead (assembled with ceramics) 2 DR-RH*
Rayhead (30-55 MBH models only) 2 DR-RHP
*Rod for Rayhead, 17-3/8″ 18 DR-LROD
Short Rod for Rayhead 1 DR-SROD**
Heater Reflector Assembly 1 DR-2REF
Pilot Access Door w/Screw 1 DR-DOOR
Pilot Shield 1 F10-PS
Pilot Line (Straight) 1 PL-2
Union Fitting, 3 Piece 1 DR-MU
DR Cross Over Bracket (45-60 MBH Nat; 45-100 MBH LP only) DR-CO
DR Flash Shield (45-60 MBH) 1 DR-FLSH 2
1/4″ – 20 x 1/2″ MS Bolt 6 DR-BOLT
1/4″ – 20 Hex Nut 6 DR-NUT
     

1Indicates the quantity of this part originally installed on the heater.  When replacing, you may choose to replace only the non-functioning part(s). If quantities are not indicated consult factory.

*30, 45 & 55 MBH PFS, PMV & PT models use DR-RHP.

**NFS, PFS models require 1 DR-SROD in addition to 17 DR-LROD‘s.